Step 5a - Fitting the Door (Cont...)
1. Take the Red Door Setting Blocks and slide two together creating an assembly, do the same with the other
two. Fit them over the Bottom Rails at each end between the Panel Glass.
2. Carefully lift the Door Glass onto the Red Door Setting Blocks using the Handle for support.
• NOTE: One person will be required to be on the inside of the enclosure.
3. Follow procedure 4 of Step 5 for fitting the packers to the glass cut-outs.
4. Carefully close the Hinge Assemblies onto the Door Glass, ensuring the gaskets and Backplate is fitted as
shown in Step 5. Line up the Hinges with the cut-outs in the Door Glass.
5. The gap between the Hinge Panel and Door Glass should be set at approximately 6mm. Fully tighten the
screws.
• IMPORTANT: Tighten the screws to 10 N/m max.
6. Slide the Red Door Setting Blocks apart and allow to fall then remove from the Bottom Rails.
• NOTE: Because of the weight of the Door Glass you may need to gently tap apart using a piece of wood
or similar. Be careful not to damage the Glass or the Bottom Rails.
⑤
Note: Two people will be required to do the following operations.
①
②
↓
↓
④
6mm
