Rolls-Royce Helicon X3, Руководство пользователя

Страница: 121 / 140

Spare Parts
10
Page 3 of 6 Doc. No.: 13S000411
Revision: A Copyright © 2010 Rolls-Royce plc
1 Ordering Spare Parts
When ordering spare parts, following information must be given:
• Name of vessel and owners' address. If possible, name and address of the building yard.
• Type of drive motor.
• Helicon type, installation number and year of manufacture.
• Item number, article number, drawing number and description of the parts. This
information can be found in the drawing appendix.
For location of Manufacturing number see chapter 3 System Description .
Please contact Rolls-Royce Marine dept. Propulsion - Ulstein or one of our Global Sales
and Service Network sites listed in chapter 9 Contact Information .
1.1 Ordering Spare Parts Separately
To ensure that correct components are shipped, it is essential that each part is correctly
specified in the order. For part identification, please refer to the parts ID in the design
drawing documentation in chapter 12 Design Drawings of this manual.
The part ID is identified as follows:
<Installation ID><Thruster ID><Unit No><EL.ref.>
• The Installation ID is found on the front page of the manual.
Example: YYSXXXXXX .
• The thruster ID is found on the cabinet door where the part is located.
Example: BOW1
• To identify the Unit No. refer to the cable diagram for the specific project or the cabinet
where the part is located.
Example: UN1 (Main Control Cabinet).
• To identify the El.ref. refer to the internal wiring diagram for the corresponding unit
and/or EL.ref. label on the component.
Example: PE900005 is the wiring diagram for the Main Control Cabinet. El.ref.: U5 is
the CPU Controller.
Following the example above, the part number for the CPU Controller unit of this
specific project should read: YYSXXXXXX - BOW1 - UN1 - U5 .