rollibot ROLLICOOL COOL 100H-20, Руководство пользователя

Страница: 20 / 24

20
RolliBot RolliCOOL 100H-20 Portable AC User Manual
Section 8. Troubleshooting
Problem Possible Cause(s) Solution(s)
The unit does
not work.
There is no electricity.
Turn it on after connecting it to a socket
with electricity.
The over ow indicator is on. Drain the water inside.
The system is protected
Wait 3 minutes until the temperature is
lowered then restart the unit.
The cooling
e ect is weak.
There is direct sunlight.
Cover any direct sunlight coming
through the windows.
Doors or windows are open; there
are a lot of people; or there are
other sources of .
Close doors and windows.
The lter is dirty. Clean or replace the lter.
The air inlet or outlet is blocked. Clear obstructions.
Excessive noise The unit is not placed on a at
surface.
Place the unit on a at and stable surface.
Leaking while
moving
Water reservoir is full. Drain the water reservoir before moving
The drainage plug may be cracked. Check the drain stop plug for cracks
Display not on
Power plug and socket contact
bad or power cord disconnect, no
power.
Check the power plug, power cord or
socket and connect it again.
There is unusual
sound
It is normal to have a slightly
stronger vibration sound in the rst
few minutes before power-up.
Will disappear after few minutes.
Water beads on
the surface
In areas of relatively high humidity,
air outlet, control panel, and other
parts may produce condensation.
It is a normal phenomenon.
Long-term cooling operation in
open spaces with windows open.
Closing windows, doors, etc. may resolve
excessive condensation.
Low fan speed may also lead to
increased condensation.
Increase the fan speed.
The opening angle of the louvers
(adjustable vents) is too small.
Increase the angle of the louvers
(adjustable vents) or set it to Oscillate
mode.
Oscillator
doesn’t work.
Oscillator function never engaged. Engage the oscillator function using the
on-screen display or Rollibot app.
User is looking at the outer front
vent. The oscillator is inside the
outer vent. (See Section 2.2 -
Components Overview, item #5 for
detailed view.)
The outer air vent is for storage purposes
and will only open and close. With
the vents open, activate oscillation
function, and look inside the front vents.
The oscillator is vertical and should be
moving. If not, power the unit o and
then back on.
Front air vent is closed.
Open the front air vent. The oscillator is
inside the front air vent and is vertical.
When the RolliCool encounters errors, the display may show certain error codes. Refer to the
table below.