5
Rollerdor RD20X2ELL Control Box, Edition 2022/1
3. SETTING UP WIRELESS
SAFETY EDGE KIT
(OPTICAL EDGE)
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
CHECKING BASE RAIL UNIT
1
Your base rail unit is already installed on one
side of the last slat of your curtain (usually
nearest the motor) it is a small black unit,
there are 2 screws one each end, undo screws
and remove the lid
(fig.8)
.
2
Check the wiring inside the base rail unit and
dip switch position
(fig.9)
Terminal 4: Green
wire [ signal ] Terminal 5: Brown wire [ power
] Terminal 6: White wire [ power
supply - ] dipswitch 1 should be on and dip
switch 2 off.
3
Batteries: The unit comes with Qty 2 AA size
3.6V lithium batteries but will work with Qty
2 AA 1.5v batteries, there is a sliding switch
to change the voltage from 3.6v to 1.5v
depending on which is used and must be
in the correct position to work.
Please pay
attention to the polarity!
4
Test safety edge connection: the RED LED on
the base rail should be out, slide dip switch
2 into the ON position, you now have 30
seconds to test the connection by squeezing
the base rail rubber, when you squeeze the
rubber the RED LED should light up, this will
confirm a good circuit, return dip switch 2 to
off. If the RED LED doesn’t light up check the
wires to make sure all connections are good
and then retest, if the red light is constantly
on as soon as you slide the switch please
contact your provider as there may be a fault
with the Optics.
The control box is supplied in Hold to Run operation for open and close, if the limits of the motor have not been set then
please set them now using the PROG (P1/UP) & DEL (P2/Down) buttons, if when you press and hold either of the buttons
the unit just beeps then you will need to put the unit into Hold to Run by pressing and holding both PROG (P1) & DEL (P2)
buttons at the same time until you hear a single beep
(fig.7)
. Once you have finished setting limits once again press and
hold both PROG (P1) & DEL (P2) buttons at the same time until you hear a single beep to return to single press operation.
fig.7
fig.8
fig.9
