4
Rollerdor RD10X2 Control Box, Edition 2022/1
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
1
The control box is currently in hold to run operation for
open and close, if the limits of the motor have not been
set then please use the open and close buttons that
can be found at the bottom right corner of the yellow
transformer (Fig.17.1) to set these limits.’
2
Once installation is complete, slide back down dip
switch ‘2’ in the control panel, this can be found on
the four dipswitch block at the bottom middle of the
receiver board (usually blue or red)
(fig.6)
.
3
For access to the base rail unit on the right side (where
the writing is), push at the end of the grey cover and
slide to the left. This will give access to the board
(fig.7)
.
4
Fix the wireless safety edge to the centre of the bottom
slat of the door on the inside with the safety edge fitted
level and square with the writing the correct way up .
5
Check to make sure both dip switches are down in the
base rail unit
(fig.8A)
, these are just off centre at the
top of the unit (usually blue
or red).
6
Set the sensitivity on the small dial
(fig.8B)
to 3 to
start. This can be adjusted for optimum operation
(smaller the number the more sensitive the unit is, and
the dial has to be set on a whole number).
7
Remove the plastic tab from the batteries and the LEDs
will blink on the safety edge unit.
8
Inside the receiver box press and hold the “PROG”
button on the receiver card (this is the card plugged
onto the board) until you hear a single beep
(fig.9)
,
then within 5 seconds press and hold the “PROG”
button on the wireless safety edge
(fig.8C)
and you will
hear another beep from the receiver box.
9
Wait several seconds until you hear 2 beeps from the
receiver box and pairing is complete.
fig.6
fig.7
2. SETTING UP WIRELESS
SAFETY EDGE KIT
(RD10X2 VELOCITY SAFETY EDGE)
PROGRAMMING BASE RAIL UNIT
PUSH
GREY
SECTION
