7
Rollerdor RD10X2 Control Box, Edition 2022/1
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
To clear memory you will need a small screwdriver.
fig.13
1
Press and hold the “RADIO PROG” button
(fig.13)
.
You will hear a beep and the red LED alongside “C1”
will illuminate.
2
Insert screwdriver between the 2 pin terminals on
the board (MR) to bridge between them
(fig.13)
.
3
Press and hold the “RADIO PROG” button
(fig.13)
.
The panel will beep 8 times and then go into 1
continuous beep. As soon as you hear this, release
“RADIO PROG” button and then remove screwdriver
from terminals and board will stop beeping.
4
Leave for several seconds and the receiver box will
beep twice to confirm end of programming.
CLEARING MEMORY OF REMOTE CONTROL
HANDSETS
MR
fig.14
1
Press and hold the “PROG” button
(fig.14A)
on
the receiver card (this is the card plugged onto the
board) until you hear a single beep.
2
Insert screwdriver between the 2 terminals on
the board (forks below “PROG” button) to bridge
between them
(fig.14B)
.
3
Press and hold the “PROG” button, the panel will
beep 8 times and then go into 1 continuous beep.
As soon as you hear this release “PROG” button and
then remove screwdriver from terminals and board
will stop beeping.
4
Leave for several seconds and the receiver box will
beep twice to confirm end of programming.
To clear memory you will need a small screwdriver.
CLEARING MEMORY OF BASE RAIL UNIT
B
A
