Page. 11
Easy Spring Ultra Skyline
Installation
Manual | v2.0
2021 ©Copyright All Rights Reserved Rollease Acmeda
SECTION C
| TROUBLESHOOTING
NO. PROBLEM
CAUSE
SOLUTION
1
Cannot find limit
Limit incorrectly Set
a)
Allow blind to raise fully
b)
If the bottom rail is too high, contacting the brackets,
then:
i.
Wind limit adjustment wheel in the direction that
would lower the shade *
ii.
When the shade starts to lower this indicates the
limit has been engaged
c)
Use limit adjustment wheel to raise or lower limit as
required
* Note : If limit wheel appears to require numerous turns, raise
the shade to approximate top limit position, un-install the
shade from mounting brackets, remove the limiter from the
tube, rotate and move limit nut to appropriate stop position.
Reassemble and re-install shade to adjust top limit.
2
Erratic Behaviour
Shade falls
Connector on wrong end
Remove and re-install on other end (See Assembly Manual,
Section E, Part A)
No Pre-Turns
Add pretensions (See Section B, Part C)
3
Shade will raise quickly
Wrong Decelerator
Remove and re-install correct Decelerator (See Assembly
Manual, Section E, Part B)
Too many Pre-Turns
Remove Pre-Turns as per Section B, Part C
4
Shade does not raise
Incorrect hand Booster
Remove control and re-orientate the booster (See Assembly
Manual, Section E, Part A)
Control is not fully engaged
with Booster
Remove control and check with booster (See Assembly Manual,
Section E, Part A)
No Pre-Turns
Add pretensions (See Section B, Part C)
