Roland MODELA Pro II ZCL-540, Руководство пользователя

Страница: 22 / 80

20 Chapter 1 Introduction
1-1 Introduction
Features

This is an optional unit for adding an A axis to the MODELA Pro II from Roland DG Corp.

The bolt-on design allows easy installation.

Simultaneous four-axis control (X, Y, Z, and A) is possible.

A unique, two-tab chuck that can be used to secure in place not only square-block workpieces but also immobile material
is included as a standard feature.

A tailstock and center drill for securing the workpiece in place more reliably are included as standard features.
Installable Model
Supported Model

MODELA Pro II MDX-540S

MODELA Pro II MDX-540

Installation on a machine equipped with either the standard table or the T-slot table is possible.

Use in combination with an ATC unit is possible.
Organization of the Documentation
Installation and operation this unit require prior knowledge of the handling and operation of the modeling machine. Before
you read this document, be sure to familiarize yourself with the handling and operation of the modeling machine.
This document describes the following.

How to install the unit

How to adjust and perform maintenance for the unit

Explanations of features added by the unit
For matters not described by this document, refer to the documentation included with the modeling machine.