Roland MODELA Pro II ZCL-540, Руководство пользователя

Страница: 51 / 80

4-3 Setting the Z-axis Origin
49 Chapter 4 Setting the Origins

In VPanel, click the [Base Point] icon.
If you're in the NC-code mode, then
select the workpiece coordinate
system you're using.
Select [Z Origin].
Click [Apply].

WARNING: This procedure makes
the machine operate. Before you
perform this procedure, check to
make sure that operation of the
machine will not create any hazard
or danger.
Click [OK].

Click [OK] to finish making the set-
ting.
Detach the sensor cable.
To Make the Tool Descend Rapidly
When it takes a long time for the tool to make contact with the sensor, turn the hand wheel on the handy panel counterclock-
wise. Be careful not to make the tool collide with the sensor. A collision makes accurate detection impossible. If a collision
occurs, redo the operation from the beginning.