3-3 Manual Tool-change
Grasping a Tool Holder by Manual Operation
Tool-change is performed automatically according to commands from the computer, but when necessary you can also
perform tool-change manually. Note, however, that this operation cannot be performed when the spindle cover is open,
during a cutting operating, or while the machine is paused.
Procedure
Close the spindle cover.
In VPanel, click the [Attach/Detach]
icon.
WARNING: This procedure
makes the machine operate. Before
you perform this procedure, check
to make sure that operation of the
machine will not create any hazard
or danger.
Choose the stocker number.
Click [Replace].
To return, click [Return].
Operation Using the Handy Panel
You can also perform this operation using the handy panel.
☞
P. 71, "Chapter 6 - Handy Panel"
55
Chapter 3 Basic Operation
