Roland Metaza MPX-90, Руководство пользователя

Страница: 44 / 120

42
3-2 Getting Ready
Chapter 3 Making Prints

Mount the center vise.
Fit the tabs on the bottom of the center
vise into the holes in the table on the
unit.
If the material tilts, place a support in
order to keep the material horizontal.
If you’re performing printing with head cap used, this completes loading of the material.
If you’re performing printing with no head cap used, then go on to the following steps.
The procedure from this point on is for when you’re not using the head cap.

Press the Power/Movement but-
ton.
The head moves and stops at the location
where the tip of the nose cap touches the
surface of the material.

Loosen the knob.
Rotate the knob counterclockwise once.
Then you can move the stopper.
Tab
Tab
Fit the tabs here in the case
of vertical mounting.
Fit the tabs here
in the case of hori-
zontal mounting.
Stopper
Knob