Roland Metaza MPX-90, Руководство пользователя

Страница: 34 / 120

32
Chapter 3 Making Prints
3-2 Getting Ready
The Printable Area
The machine's printable area is as follows.
Head Caps
Using the head cap is usually recommended.
When the head cap is used, the machine automatically tracks the surface height of material and sets the posi-
tion of the head. Therefore you do not need to set the head position for printing. You can make a print even
on a cylindrical material. (There is an upper limit of the height that can be tracked.) It is recommended to use
the head cap for usual printing.

P. 77, "4-5 Printing on a Curved Surface," p. 98, "The Replacement Cycle for the Head Cap"
Remove dirt and dust from the printing surface.
If you carry out printing without removing dirt and dust attached to the printing surface, it may deteriorate the
printing quality. Make sure to remove dirt and dust from the printing surface before you perform printing.
For test printing, it is advisable to use materials with no scratches or stains.
Some materials may cause scratches and stains on the head cap during printing, which may affect the print-
ing quality. Scratches and stains on the materials may also damage the head cap and result in poor-quality
printing. Therefore, for your prior checks on printing, we recommend you perform test printing with materials
without any scratches or stains.
Center line
Center line
Top view of the table
Printable Area
50mm × 50mm
Maximum Printable Area (80mm × 80mm)
The setting by METAZA Driver is required.
If an image exceeds the printable area, the print
result might become uneven in the outside of
the printable area.
Head cap with
scratches or
stains
Scratches or stains caused by the head cap
Printing
Surface
Scratches
or stains