10
Q7:
When
the
front
and
back
are
cut,
they
become
misaligned.
A: If the material shifts while being cut, try using more securing material or changing the method of securing the
material (double-sided tape, instant glue, or creating a negative form to secure the material).
Q8:
Is
there
a
way
to
make
the
material
surface
(Z0)
setting
more
accurate?
A: When a thin cutter is lowered, it is very difficult to recognize the moment that the tip contacts the material
surface.
If this is not set correctly, a large load may be applied, resulting in the cutter breaking.
Try performing the following operations.
- Recognizing the moment that the cutter tip contacts the material when the cutter is lowered
After applying a fine powder to the material surface, painting it with white correction fluid or applying a spray that
becomes powdery after it has dried, lower the cutter and stop when scattered powder is seen at the moment that
the tip makes contact.
Otherwise, place a sheet of paper on the material surface to recognize the contact point from the paper
movement.
Lower the tool with single clicks of the
－
Z key; do not hold down the key.
*The setting must be specified with iModela Controller.
- Surfacing to create a precise height
Gradually grind down the high point in small amounts to create a precise material surface.
Set the cut surface as the new material surface.
With material that cannot be cut or material with a height difference on the surface, setting the low point as the
material surface (Z0) may cause a large load in the higher areas when cutting is started.
For accurate cutting, it is more effective to cut the material surface, even though this may seem tedious.
Содержание iModela
Страница 1: ...iModela Trouble Shooting...
