Chapter 3 Getting Ready for and Performing Cutting
Provisionally tighten the character
cutter in the engraving-tool holder,
and install the engraving-tool holder
on the tool carriage.
Press the SET SURFACE key to lower
the tool, then loosen the screw for the
engraving-tool holder.
Gently lower the cutter until the tip of
the cutter touches the surface of the
material.
Tighten the screw securely to secure
the cutter in place.
Hexagonal
screw driver
Material surface
Hexagonal
screw driver
Hexagonal
screw driver
2. Rotate in the direction
of the arrow.
1. Turn in the
direction of the
arrow to tighten
provisionally.
Engraving-tool
holder
Use the spanner to tighten and secure in place.
29
3-3 Installing a Tool
Содержание EGX-30A
