Roland EGX-30A, Руководство пользователя

Страница: 36 / 52

Chapter 3 Getting Ready for and Performing Cutting
Test Cutting
The EGX-30A can perform test cutting to check whether cutting conditions are correct. Test cutting is also recommended to
determine optimal cutting conditions, such as the compatibility of the material and tool, and the cutting speed.
If the results of test cutting are less than satisfactory, refer to page 33 " About Tools and Materials" and page 35 " Setting
Cutting Conditions" and redo the settings.
It may be a good idea to use a blank area of a piece of material or an extra scrap for test cutting.
Procedure

Use the SELECT key to choose the
cutting mode.
The LED for the selected mode lights
up.

Check again to make sure that the correct material and tool for the selected mode have
been loaded and installed.

Hold down the SET SURFACE / TEST
key for one second or more.

Test cutting starts.
Required Area
15 x 15 mm (5/8 in. x 5/8 in.)
34
3-3 Installing a Tool