15
3DISON AEP U
ser M
anual
Maintenance
※ Cleaning Nozzle
If Hot-End got stained with filament remains or foreign object, it will affect the quality of
printing. Please remove filament remains or foreign object on the nozzle using wire brush
& tweezer. Be careful not to scrub too much to prevent abrasion of the nozzle.
(Gloves are essential for safety, caution for burn)
※ Jamming Extruder
Pre-Heating the extruder with higher temperature than required temperature of the
material. (Around 10 degree higher)
Please push 1.8mm Pin(Provided tool) into the jammed extruder from the entrance of
filament loading whole. (Caution: Filament will be hot due to Pre-Heat)
※ Managing for Dual Hot-End Difference of Nozzle Level
Dual Hot-End can be adjusted for height through bolts on both sides of the etruder.
(Using Hex key wrench)
UP: Tighten a bolt / Down: Loosen a bolt.
Caution: If you loosen a bolt too much, the mount bar of extruder will be vibrated.
※ Keeping Filaments
It may differ slightly depending on the filaments but, filament quality can be affected by
moisture. Please keep the filament in an Air-Tight container.
