11
3DISON AEP U
ser M
anual
Leveling the Printing Bed
How to use 3DISON AEP
1
2
3
4
5
※ We recommend using Auto-Leveling after Standard-Leveling has been completed.
※ Despite of using Auto-Leveling function, if the gradient of the printing bed is too steep because no
zero point leveling has been done, Z axis will operate too much and may lower the quality of the output.
※ If there happens to be a some distance between the nozzles and the bed, adjusting is required
before printing. Make sure to turn the two knobs at the same time with both hands.
Put a sheet of A4 paper onto
the printing bed before manual
leveling.
In Creator K, put the check mark
in the Auto-Leveling item when
generating G-Code. Auto-
Leveling function automatically
works during the printing.
Select Utilities > Standard
Leveling on the display menu.
When pressing the OK button,
the extruder will move to the
front, back, left, right and center.
Select Utilities > Auto Leveling
setting. When you put an A4
sized paper on the Bed-Plate
and press right key, the extruder
will be place at the center. Use
Up/Down Key to make appropria
te distance between the nozzle
and the paper. Press OK Button
after the Auto Leveling setting.
When the nozzle lands on each
position of the front, back, left
and right, adjust the 4 round nuts
to the right height in the same
way. If you feel the paper is
slightly scratchy, it is fine. Press
OK button to finish the leveling.
