Rohnson R-974, Инструкция по эксплуатации

Страница: 8 / 13

7
SWITCH to “stop” position to stop make espresso coffee. After a few seconds, if indicator 2
is illuminated again, you can make espresso coffee continued by turning “START/STOP
SWITCH to “start” position, the indicator 2 is cycle on and off to maintain the water
temperature is hot enough.
5. You should press the I switch and hold for 3s to turn off it manually when desired
coffee is obtained or the colour of coffee changes weak obviously, the indicator goes out and
the coffee maker stops working, your coffee is ready now.
WARNING : Do not leave the coffee maker unattended during making the coffee, as you
need operate manually sometimes!
6. After finishing making the coffee, you can take the metal funnel out through turn
clockwise. Then pour the coffee residue out with the steel mesh pressed by press bar.
7. Let them cool down completely, then rinse under running water.
FROTHING MILK/ MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Note: during making steam, the metal steel must be assembled in position.
Method:
1. Prepare espresso coffee first with container big enough according to the part “MAKE
ESPRESSO COFFEE”, make sure that the steam controller is at the off position.
2. Press the switch I and turn MODE switch to “Froth” position and keep Start/stop
switch on “stop” position, waiting for until the indicator 2 is illuminated.
3. Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are
recommended to use whole milk at refrigerator temperature (not hot!).
Note : In choosing the size of jug, it is recommended the diameter is not less than 70
±
5mm,
and bear in mind that the milk increases in volume by 2 times, make sure the height of jug is
enough.
4. Turn the steam controller in anti-clockwise slowly, steam will come out from the
adjustable steam outlet.
Note : Never turn the steam controller rapidly, as the steam will accumulate rapidly in short
time which may increase the potential of the risk of explosion. During operation, if the
indicator 2 is extinguished, you should turn the steam controller to off position and waiting
for until the indicator 2 is illuminated again and turn the steam controller in anti-clockwise,
the steam will come out again.