Rohm EXTRA-RV, Перевод оригинального руководства по эксплуатации

Страница: 13 / 24

Disassembly/assembly of the drill chuck | 4
Drill Chuck EXTRA -RV 13 / 24
4 Disassembly/assembly of the drill chuck
WARNING
Starting machine during assembly.
Hand injuries.
Ø Prior to assembly, disconnect the power supply of the corded
or cordless drill (pull the mains plug/remove the battery).
The following assembly of the drill chuck is a recommendation of RÖHM .
The assembly must be carried out in accordance with the machine manu-
facturer's operating manual. If damage occurs,
RÖHM shall not be liable.
4.1 With spindle stop
Disassemble the drill chuck
§
Power supply disconnected (mains plug pulled/battery removed).
1. Open the clamping jaws of the drill chuck .
2. If installed, screw out the retaining screw (left-hand thread) and re-
move it (Figure A, page 14).
3. With the short shank forward, clamp an Allen key with a key width of 8
- 10 mm into the
drill chuck (Figure B, page 14).
4. Use an angle screwdriver for screws with hexagon socket to loosen the
drill chuck and unscrew it from the machine spindle (right-hand thread)
(Figure C, D page 14).
ü
drill chuck disassembled.