Rohde & Schwarz R&S OSP-B157W8, Начало работы, Страница: 13 / 43

Preparing for Use
R&S
®
OSP
‑
B157W8 (PLUS) R&S
®
OSP
‑
B157WX
13 Getting Started 1178.5808.02 ─ 03
3 Preparing for Use
● Unpacking and Checking ................................................................................ 13
● Mounting the Base Module ............................................................................. 13
● Mounting the Extension Module ......................................................................19
● Installing or Updating the Firmware ................................................................ 24
● Putting into Operation ..................................................................................... 25
3.1 Unpacking and Checking
If your delivery includes a module that is not mounted in a switch unit, be espe-
cially careful with unpacking the module, which is not protected in a casing.
Check the delivery for completeness according to the included shipment list. If the
delivery is incomplete, contact Rohde
& Schwarz.
Retain the original packing material. If the instrument needs to be transported or
shipped later, you can use the material to protect the control elements and con-
nectors.
Mounting modules into switch units
●
If you have received one or more modules that are already integrated in
switch units, you can skip the chapters Mounting the Base Module and Mount-
ing the Extension Module . Proceed with Chapter 3.5, "Putting into Operation" ,
on page 25.
●
If you have received one or more modules that are not yet integrated in
switch units, proceed with chapters Mounting the Base Module and Mounting
the Extension Module .
3.2 Mounting the Base Module
Mounting the base module R&S OSP-B157W8 or R&S OSP-B157W8PLUS into
an R&S OSP150 or R&S OSP120 switch unit requires the space of two slots: rear
slots A12 and A13 together with front slots A12F and A13F. Typically, the rear slot
A11 remains free, but optionally it can remain occupied by a single-slot module
Mounting the Base Module