Rohde & Schwarz 6144.7800.02, Руководство по эксплуатации

Страница: 58 / 189

Configuring with the R&S ZS 4200 R&S EU4200C
3.15 6174.8456.02-01
Select Audio Interface
This parameter is used to select the audio interface of the radio. If the
Analog Audio is selected, the RX Audio Basic interface X10 is used. If the
E1 is selected, the E1 – Communication Data interface X13 (RX) is used.
For more information on E1 interface please refer to chapter 3.12 Audio via
E1 Interface. If VoIP is selected, audio data will be transmitted via Ethernet
by the data interface X6 (RX) (see chapter 3.14).
RX Input Sensitivity
There are two settings for the sensitivity of the receiver:
The Low Distortion (LD) setting is recommended for strong interference
signals at the antenna input. It reduces sensitivity, and thus improves
immunity.
The Low Noise (LN) setting increases the sensitivity, and thus improves
the reception of weak signals.
Set/Get Values for
Preset Page
200 preset pages can be stored in the radio and called up. Each contains
the frequency, offset (insignificant for RX module) and spacing parameters.
These parameters can be set for each preset page.
Installation Info
Information (up to 20 characters) can be entered to describe the radio
more precisely.
Location Info
Only the first 20 characters entered by using the R&S ZS 4200 appear on
the radio display.
IP Address
An IP address must be assigned for each radio module, which allows each
module to be uniquely identified and operated in remote operating mode.
Additionally, specifying the netmask and the gateway makes it possible to
work within different subnets via a router.
Second IP Address
Enabled
The radio supports 2 IP addresses on the same physical LAN port
("IP Aliasing"). This parameter enables or disables the use of the second
IP address.
If disabled, the radio serves all LAN connections on the primary interface
(parameter "IP Address").
If enabled, VoIP services (SIP/RTP) are only accessible via the primary IP
address (parameter "IP Address"), while all other service types (e.g.
GB2PP, SNMP) can be accessed via the second IP interface (parameter
"Second IP Address").
Second IP Address
This parameter configures the Second IP address in IPv4 or IPv6 mode if
the functionality "Second IP Address Enabled" has been enabled.
ACL
(Access Control List)
Here you can enter the IP addresses of the remote control systems or
clients that are allowed to access the radio. This protects the radio against
unwanted/unknown accesses. If the list is blank (default), then any client
with any IP address can access to the radio.
BSS Enable
The parameter is used to enable or disable the Best Signal Selection
functionality. For more information please refer to chapter 3.11 Best Signal
Selection.