Operation
R&S
®
EB510
17
Getting Started 4091.7338.02 ─ 01
●
X14 REF OUT BNC output provides a 10
MHz reference frequency normal for
synchronization of other devices. Frequency normal dependent on selected
internal or external reference.
●
X15 GPS/TR IN BNC input for an external 1
sec trigger pulse, e.g. from a GPS
device.
5. AUX / AUX Audio.
●
X3 AUX AUDIO is a 25-pin D-Sub female connector with the output of different
audio signals.
●
X4 AUX is a 25-pin D-Sub female connector for controlling external antenna
switching units.
6. Video Output.
X8 VIDEO A, X9 VIDEO B SMA outputs provide analog I-Q baseband or AM and
FM demodulated signal for further processing. These outputs also can be switched
to output-controlled analog intermediate frequency (IF) in two channels with an
adjustable carrier frequency of 0 Hz to 70 MHz.
7. Serial Interfaces – EIA 232D Compatible.
●
X5 COM2, 9-pin D-Sub male connector.
●
X6 COM1, 9-pin D-Sub male connector.
X5 and X6 can be used for serial GPS devices according to the NMEA0183 stand-
ard. Use this connector for an external GPS device to determine the location and
the exact time of the R&S
EB510.
8. Grounding Post for Earth / Chassis Ground.
Signal Interfaces
All I/O, RF, signal interfaces (X3-X6, X8-X15) must be operated with double
shielded cables.
Interface X7 LAN
A CAT7 LAN cable must be used for this Gigabit capable interface.
Rear-Panel Tour
