5
Smart Home Monitoring | In-Wall Switch or In-Wall Dimmer | Manufacturer's Installation Guide
The Jasco Auxiliary switch is required for Multi-Switch 3-way or 4-way installations.
Connecting the traveler terminal of this switch to a standard, non-Jasco switch will cause
damage or result in improper function. If this switch is a part of a 3-way or 4-way multi-
switch installation, do not connect the traveler wire or apply power until Jasco Auxiliary
switches are correctly installed. For more information on 3-way or 4-way installations, view
the manual or quick-start guide that comes with the Jasco Auxiliary switch.
7. Connect the green or bare copper ground wire
to the GROUND terminal.
8. Connect the black wire that goes to the light to
the terminal marked LOAD.
9. Connect the black wire that comes from the
electrical service panel (Hot) to the terminal
marked LINE.
10. Connect the white wire to the neutral terminal.
Note:
UL specifies that the tightening torque for the
screws is 14 Kgf-cm (12 lbf-in). The Traveler terminal is
only used for 3-way or 4-way wiring and should
remain insulated if the switch is being installed in a
2-way system (one switch & one load).
11. Insert Switch into the switch box being careful
not to pinch or crush wires.
12. Secure the switch to the box using the supplied
screws.
13. Mount the wall plate.
14. Reapply power to the circuit at fuse box or circuit
breaker and test the system.
