4
Smart Home Monitoring | In-Wall Switch or In-Wall Dimmer | Manufacturer's Installation Guide
Single, Dual and Triple Gang Boxes
When installing the In-Wall On/Off switch in multiple
gang boxes it may be necessary to break off one or
both of the scored tabs on the front yoke.
Wiring Instructions
1. Shut off power to the circuit at circuit breaker or
fuse box.
Warning:
Verify power is OFF to switch box before
continuing.
2. Remove wall plate.
3. Remove the existing switch's mounting screws.
4. Carefully remove the existing switch from the
switch box. DO NOT disconnect the wires.
5. There are up to five screw terminals on the
existing switch; these are marked
A. LINE (Hot) — Black (connected to power)
B. Neutral — White
C. LOAD — Black (connected to lightning)
D. GROUND — Green/Bare
E. TRAVELER — Red/Other
Match these screw terminals to the wires connected
to the existing switch.
6. Disconnect the wires from the existing switch.
Be careful to label wires according to the
previous terminal connection.
