Rogers PRT42, Инструкция по установке и программированию

Страница: 14 / 30

PRT42 and PRT42-BK v1.0 fv72 EN Rev.C
15
Reader rearming operation can be done by TOGGLE or TOGGLE LTD Users. The action needed by a TOGGLE
user to rearm the reader is to read twice the TOGGLE card or to enter twice the TOGGLE PIN code — however,
when reader operates with the Card+PIN mode activated, user needs to do both things, read a card and enter a
PIN. TOGGLE LTD users may rearm the reader simply by a single use of their identification tag (Card, PIN or
both when Card+PIN option is active).
If the reader operates with input line defined as Ready Input the arming of a reader can be carried out only
when this input remains in active condition, when such a input is not triggered (passive state) every attempt to
arm reader will be rejected. Usually the Ready Input should be connected to the Alarm System Control Unit’s
output which is intended to indicate that the Alarm System is ready for arming (Ready Output on an Alarm
System Control Unit).
6.4 Opening the Door
In order to open the door user must present its card, enter its PIN or do both things when Card+PIN mode is
active. Each time card is read or key is pressed reader activates orange LED SYSTEM and generates short beep.
After successful identification reader activates door lock for predefined time (see Installer Programming Mode,
C1 and C2 digits which define Door Lock Triggering Time). The activation of a lock is signalized on green LED
OPEN, this led remain ON as long as door lock is energised. When access to room is denied reader generates
long beep. The access to a room can be disabled in two situations:
When Card or PIN is unknown or
When reader operates in ARMED mode and has set an option: Access Disabled When Reader Armed
If the second scenario occurs the TOGGLE or TOGGLE LTD. user may use its identifier (Card, PIN or both when
Card+PIN mode is active) to switch reader from ARMED to DISARMED mode thus enabling NORMAL users to
open the door or may switch reader from DISARMED to ARMED mode in order to disable NORMAL users to open
the door.
6.5 Alarm Signalization
The PRT reader may signalize three type of alarms: Door Forced, Prealarm and Door Ajar. The alarm
signalization is carried out on dedicated output line (Alarm Output) and optionally on internal buzzer (see
option:
Door Alarm Indication on Internal Buzzer ). Each alarm is signalized in different way (see table
below). Duration of alarm, regardless of its type is ~3 minutes. An alarm can be stopped within 3 minutes time
from its start by entering any identification tag (Card or PIN) registered in the reader. The Door Ajar alarm is
immediately stopped, once the door is closed. If more than one alarm is triggered, the reader indicates the
alarm with the highest priority. The Forced Entry and Door Ajar alarms may occur only if the reader operates
with a door open sensor.
Alarm Signalization on Output and/or Buzzer
Alarm type Priority Indication method Alarm situation
Door
Forced High In cycles with the following sequence: Active -
4 sec., Pause - 4 sec.
4 s
4 s
Door opened without use of valid
card or PIN.
Prealarm Medium In cycles with the following sequence: Active -
1 sec., Pause - 1 sec.
1 s
1 s
Detection of 3 consecutive
attempts to enter an unregistered
(unknown) card or PIN code.
Door Ajar Low In cycles with the following sequence: Active -
1 sec., Pause - 1 sec., Active - 1 sec., Pause
- 5 sec. After access has been granted
and door opened it is left ajar for
the time exceeding the door open
time setting (see C2C3 parameter
in Installer Programming Mode).