EN
39
8
Travel acquisition
For the system to function correctly, the door travel must be acquired by the control.
Before starting:
1. Move the door into the fully closed position. The control unit determines the open and close travel values
electronically. If any difference found between the two travel values, the acquisition procedure fails.
2. Press
TEST
WII8)78QSHIMRGLETXIVERHGLIGOXLIGSQQERHWMKREPERHWEJIX]HIZMGIWXEXIW-JER]WEJIX]
HIZMGIWEVIRSXMRWXEPPIHNYQTIVXLIVIPEXMZIGSRXEGXSVHMWEFPIXLIHIZMGIJVSQXLIVIPEXMZITEVEQIXIV
,
,
).
3. Check that the limit switches are set correctly. Check the door closed limit switch in particular.
ACQUISITION PROCEDURE:
PROG
PROG
TEST
TEST
TEST
AP P-
FC
AU to
x4 s
APERTURA
APERTA
CHIUSURA CHIUSA
CHIUSA
Vedi Segnalazioni degli ingressi (Cap. 12) e Allarmi (Cap. 13)
1 click
Esempio
14
AU to
Sì
No
Sì
• Press and hold
PROG
for 4 seconds.
$3 3
is shown on the display.
• Press
PROG
again.
$XWR
is shown on the display.
• The door starts opening at low speed.
•
8LIHSSVWXSTWFVMIƽ][LIRMXVIEGLIWXLIHSSVSTIRPMQMXW[MXGL
$XWR
ƽEWLIWSRXLIHMWTPE]
• The door closes until it reaches the door closed stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
•
$33(
: acquisition error
•
$33/
: travel length error
•
$33&
HSSVGPSWIHPMQMXW[MXGLIVVSV'LIGOXLEXXLIHSSVGPSWIHPMQMXW[MXGLMWWIXGSVVIGXP]WIIGLETXIV
)\EQTPI
'037)(
See safety input (Chap. 12) and Alarm and fault (Chap. 13)
34)2-2+
34)2
'037-2+
'037)
Yes
Yes
Содержание B70/1B
