Cerber
®
C41V1/Cerber
®
C41V4
H
OOKUP
I
NSTALLATION
& P
ROGRAMMING
B
OOK
16
SYSTEM PARAMETER PROGRAMMING
E
NTERING
THE
P
ROGRAMMING
M
ODE
OF
S
YSTEM
P
ARAMETERS
[ * ] [ 8 ] [I
NSTALLER
'
S
C
ODE
]
Entering the programming mode of system parameters is achieved by
[*][8][Installer's Code]
command, only in disarmed mode. The system
programming options are explained bellow.
The default Installer's Code is [0269] and it is strongly recommended to be
changed after installing the alarm system.
After pressing [*][8][Installer's Code], the keypad buzzer will sound 3 beeps,
and the LEDs will display as follows:
LED
LED S
TATE
READY
OFF
SYSTEM
Blinking
ARMED
ON
Zone LEDs
OFF
Now you have just entered the system parameter programming mode.
To leave the programming mode press [#] key.
System parameters are grouped in sections counted from 01 to 14. To enter
each section press the 2 corresponding digits.
After entering the 2 digits, the keypad buzzer will sound 3 beeps an the
LEDs will display as follows:
LED
LED S
TATE
READY
ON
SYSTEM
Blinking
ARMED
ON
Zone LEDs
OFF
This moment you are inside the chosen section.
To leave the section press [#] key.
Certain programming entries may require entry of data in HEX. To enter data
in HEX format, first press the [*] key followed by a number according to the
data inthe table bellow:
