Roda RSP-1000, Руководство по эксплуатации

Страница: 21 / 23

21
Fig. 1 Fig. 2
4.5 For using of the convector on the floor, set the support, as shown in Figures 3.1 – 3.3.
Fig. 3.1 Fig. 3.2 Fig. 3.3
Set the convector in operational position.
Place the convector on supports in the room is similar (see Fig. 2). The distance from the back wall of the
convector to objects (furniture, curtains, etc.) must be at least 15 cm.
For portable version:
- Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool;
- Do not use this heater if it has been dropped;
- Do not use if there are visible signs of damage to the heater;
- Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.
5 ORDER OF OPERATION
5.1 Connect the convector card plug to the power socket. Pres the switch key to “I” position (keys of the
power regulator to “I”+”II” position). Set the handle of the thermostat to the scale value close to the value – “6”.
Wait a few hours for the temperature to stabilize.
When the temperature in the room reaches the desired value (you can check the temperature by means of
a thermometer) leave the control handle in this position.
If the temperature does not suit you change the position of the control handle. This temperature will be
automatically maintained in the room later on.
5.2 Operation in the model of the room protection from freezing.
This mode is used to keep the temperature at approximately 7°C in the room when you are absent from the
house for a prolonged period (i.e. more than 24 hours).
Set the switch key to position “I” (keys of the power regulator to position “I”+”II”). Set the thermostat handle
into position

. The convector nice automatically maintain the temperature in the room at the plus level
(5…7)
°
C, this protects the room from freezing.
5.3 Disconnection of the connector from the mains set the switches keys to the switched off position “0”, set
the thermostat handle to the position with the designation

and disconnect the power cord plug from the
mains socket.