Roda R2000 Truck, Руководство пользователя

Страница: 11 / 53

LUBRICATION
ALWAYS STOP THE MANURE SPREADER, TURN OFF ENGINE, AND REMOVE KEY BEFORE
SERVICING, REPAIRING, OR CLEANING. USE SAFE SHOP PROCEDURE AND EXERCISE
CAUTION WHEN WORKING ON THIS MACHINE!
It is extremely important to properly lubricate your new RODA machine before it is used for the first time. If
the mechanical drive components of your unit are not protected from shock and frictional abrasion, the wear
rate of these components will be vastly accelerated and their life span will be drastically reduced. For proper
care and maintenance, your machine should be serviced with engine oil, multipurpose grease, and fluids
specified below.
It is extremely important that the lubrication guide be followed. For lubricating bearings, use good quality
multipurpose grease. Pump the grease in slowly. Roller chains should be lubricated with engine oil, or a spray-
on chain lubricant and then the spreader operated under a no-load condition. This will allow the roller chains to
be thoroughly lubricated and thus minimize heat-up during operation.
DESCRIPTION INTERVAL LUBRICANT
ROLLER CHAINS 15-20 HOURS OIL
APRON BEARINGS 15-20 HOURS GREASE
APRON GEAR CASES ANNUALLY 75w90 SYN GEAR LUBE
APRON CHAIN WHEN PARKED 30WT OIL
HYDRAULIC OIL LEVEL DAILY ISO 32 HYDRAULIC OIL
DRIVELINE 15-20 GREASE
CAST FLANGE BEARINGS 15-20 HOURS GREASE
PILLOW BLOCK BEARING 15-20 HOURS GREASE
SLOP GATE PIVOT POINT 15-20 HOURS GREASE
ALWAYS REPLACE ALL SHIELDS AFTER MAINTENANCE AND LUBRICATION IS COMPLETE
11