Position "ON"
Works setting:
The headlight is illuminated in the analogue and digital operations, depending on the
direction of travel.
Position „OFF“
In the
analogue operation
, the headlight is deactivated.
ON
1 2
Drivers Cab 2 ON
Drivers Cab 1 ON
ON
1 2
Drivers Cab 2 OFF
Drivers Cab 1 OFF
GB
GB
14
3
Maintenance of the model
Starting locomotive operation
Unwrap model:
Take out the model cautiously
with foil (fig. 1).
Operating instructions:
Before use is advisab-
le to let the loco go around about 30 minutes for-
wards an 30 minutes backwards without load, to
obtain an optomal circuit and best tractive power.
The smallest radius this model should run is
R2
of
the ROCO track system (R2 = 358 mm).
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no.
46400, Roco track cleaning van
, or item
no.
10002, Roco track cleaning rubber
, for
removing heavy dirt.
Fittings:
Operation is possible with different
couplings (fig. 2). We recommend using the Roco
close coupling.
In the enclosed accessory bag you will find small
kits to be fitted on your locomotive. Please
mount
them cautiously.
Attention!
Use glue only if indicated (fig. 2+3).
Running in digital mode:
Remove the jumper from the interface.
Finally put the plug of the chip into the interface
as shown in fig. 8.
A.C. operation:
see fig. 11
To enjoy your model for a long time, it is neces
-
ary to
service
it regulary (i.e. after it has been in
ope-ration for approximately 30 hours).
1. Cleaning of wheel contacts:
Wheel cont-
acts easily get dirty on tracks which are not en-
tirely clean. Use a small brush to
remove dirt
from spots marked in fig. 6. Prior to cleaning the
contacts dismantle the bogie (fig. 5).
2. Lubrication:
Apply
tiny oil drops
to spots
marked in fig. 9. Prior to lubrication dismantle lo
-
comotive (fig. 4). We recommend using item no.
10906, Roco oiler
. For lubrication the gearparts
(e.g. cogwheels, worm) we whould recommended
our Roco
special grease
(item no.
10905
).
Attention:
Please do not oil these parts when
using our grease.
3. Change of traction tyre:
Remove the gear
cover (fig. 5). Take out
wheel set
and remove
traction tyre
using a pin or a fine screwdriver
(fig. 7). When pressing on the new traction tyre
please
avoid twisting it
.
4. Carbon Brush Changing:
First remove loco
body (fig. 4), and then the motor (fig. 10).
Assembly:
During assembly please take care of
correct position of contacts.