6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
• While holding the Spindle with the Arbor Wrench, set the pins of the Spindle Nut Spanner into
the holes of the Spindle Nut and tighten it securely
(FIG 4)
.
• Using a good quality Teflon sealing tape (Not Included), thread the 1/4” MNPT, Male quick
disconnect inlet fitting into the air inlet.
CONNECTION
• Be sure that the air supply to the tool is clean and dry. Moisture in the supply line will quickly
damage the motor and valves.
• A minimum 3/8” I.D. air line should be used for optimal performance.
OPERATION
• Connect air supply, move throttle safety lever forward and depress Paddle to begin rotating
action. Speed is regulated by pressure applied to the Paddle.
MAINTENANCE
• Add several drops of air tool oil before each use by dropping directly into the air inlet.
• If tool is to be unused for an extended period, add 10 drops of air tool oil directly to the air
inlet, rotate the tool motor by hand several times to distribute the oil throughout the motor and
gearbox then store the tool, handle up.
FIG. 4
Arbor Wrench
Spindle Nut
✓
✓
Spindle Nut Spanner
✓
