Chain Saw Sharpener
en
8
- Ensure switch is in “off” position when plugging
in.
18. Use outdoor extension leads
-
When the tool is used outdoors, use only extension
cords intended for outdoor use and so marked.
19. Stay alert
- Watch what you are doing, use common sense
and do not operate the tool when you are tired.
20. Check damaged parts
- Before further use of tool, it should be carefully
checked to determine that it will operate properly
and perform its intended function.
- Check for alignment of moving parts, binding
of moving parts, breakage of parts, mounting
and any other conditions that may affect its
operation.
- A guard or other part that is damaged should be
properly repaired or replaced by an authorized
service centre unless otherwise indicated in this
instruction manual.
- Have defective switches replaced by an
authorized service centre.
- Do not use the tool if the switch does not turn it
on and off.
21. Warning
- The use of any accessory or attachment other
than one recommended in this instruction
manual may present a risk of personal injury.
22. Have your tool repaired by a qualified person
- This electric tool complies with the relevant
safety rules. Repairs should only be carried out
by qualified persons using original spare parts,
otherwise this may result in considerable danger
to the user.
23. If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to avoid a
safety hazard.
24. For tools intended to be connected to a water supply:
- For tools provided with a PRCD: Never use the
tool without the PRCD delivered with the tool,
- For tools provided with an isolating transformer:
Never use the tool without the transformer
delivered with the tool or of the type as specified
in these instructions,
- Replacement of the plug or the supply cord shall
always be carried out by the manufacturer of the
tool or his service organisation,
- Keep water clear off the electrical parts of the
tool and away from persons in the working area.
SpeCiaL SafeTY inSTruCTiOnS
The chain grinder must not be used for grinding
anything other than power saw chains.
Always use protective goggles and ear protection
when using the chain grinder.
Never used damaged grinding discs.
Never use grinding discs that are too large or with a
hole diameter that is too large.
Never use discs with a maximum RPM less than that
of the tool.
Never tighten the outer flange too much, as this may
damage the grinding disc.
Never stick your hands into the working area while
the chain grinder id running.
Never allow the disc to be in contact with the item
to be worked - or other objects – when starting the
chain grinder. Let the grinding disc run for around
one minute before commencing grinding.
Содержание ShopSeries RS8000
