Rockwell ShopSeries RS2212, Руководство пользователя, Страница: 9 / 12

9
CoRdleSS dRill eN
waRNiNg:
When battery charge runs out
after continuously use or exposure to direct
sunlight or heat, allow time for the tool to cool down
before re-charging to achieve the full charge.
NoTe:
A fully-discharged battery will take
approximately 60 minutes to become fully charged.
After 60 minutes, a timer circuit inside the charger will
activate to switch off the charging system. When a
partly discharged battery is charged, it may become
fully charged before the timer circuit is activated. In
this case, a safety cutout inside the battery pack will
terminate the charging process. The safety cutout
will also terminate the charging process if the internal
temperature of the battery pack gets too high.
4. To ReMove oR iNSTall BaTTeRy PaCK (See fig.B)
Locate latches on side of battery pack and depress
both sides to release battery pack from your drill.
Remove battery pack from your drill. After recharge
insert the battery pack into drill’s battery port. A
simple push and slight pressure will be sufficient.
oPeRaTiNg iNSTRuCTioNS
1. oN/off SwiTCh
Depress to start and release to stop your drill. The on/
off switch is fitted with a brake function which stops
your chuck immediately when you quickly release the
switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
waRNiNg:
Do not operate for long periods
at low speed because excess heat will be
produced internally.
2. SwiTCh loCK
The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
place the direction of rotation selector in the center
position.
3. ReveRSiBle (See fig. C1, C2)
For drilling and screw driving use forward rotation
marked “
” (lever is moved to the left). Only
use reverse rotation marked “ ” (lever is
moved to the right) to remove screws or release a
jammed drill bit.
waRNiNg:
Never change the direction of
rotation when the chuck is rotating. Wait until it
has stopped.
4. ChuCK adjuSTMeNT (See fig. d)
To open the chuck jaws rotate the front section of
the chuck. Insert the drill bit between the chuck jaws
and rotate the front section in the opposite direction.
Ensure the drill bit is in the center of the chuck jaws.
Finally, firmly rotate the front chuck section in the
opposite directions. Your drill bit is now clamped in
the chuck.
5. ToRque adjuSTMeNT aNd haMMeR oR dRilliNg
CoNTRol (See fig. e)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when the
torque adjustment ring is set on a higher setting. The
torque is less when the torque adjustment ring is set
on a lower setting.
When drilling in wood, metal, plastic and screwdriver
choose the drill position .