Rockwell RK2511, Руководство по эксплуатации

Страница: 7 / 24

7
12V CORDLESS SCREWDRIVER ENG
SymbOLS tEChNICAL DAtA
OPERAtING INStRuCtIONS
NOtE: Before using the tool, read the
instruction book carefully.
ChARGING
A) bAttERy ChARGING
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the machine is
switched off by means of a protective circuit: The chuck
no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
When the battery is charged for the first time and
after prolonged storage, the battery will only accept
approximately 60% charge. However, after several
charge and discharge cycles the battery will accept a
100% charge.
b) tO REmOVE OR INStALL bAttERy PACK (SEE A)
Depress the battery pack release button to release and
slide the battery pack out from your tool. After recharge,
slide it back into your tool. A simple push and slight
pressure will be sufficient.
OPERAtION
1. fIttING AND REmOVING bItS (SEE b)
To use any one of the short bits supplied, insert the bit
into the chuck. To remove the bit, simply pull it out of
the chuck.
2. ON / Off SWItCh (SEE C)
Depress the switch to start the tool and release it to
stop your tool. The on/off switch is fitted with a brake
function which stops your chuck immediately when you
quickly release the switch.
It is also a variable speed switch that delivers higher
To reduce the risk of injury, user must read
instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Direct current
Charger voltage
Voltage
No load speed
Number of clutch positions
Max torque
Machine weight
120V~60Hz
12V
0-350 / 0-1300rpm
15+1
210 in.lbs
1.9lbs