22
MP-Series Food Grade Servo Motor Installation Instructions
Publication MP-IN004D-EN-P — April 2009
Accessory Kits
Factory available accessories for MP-Series Food Grade motors are described
below.
Motor Cables
Factory manufactured feedback and power cables are available in standard cable
lengths. They provide environmental sealing for IP66 and IP67 ratings and proper
shield termination. For a complete listing of available cables refer to your drive
manual, contact your nearest Rockwell Automation sales office, or access the
information from the references in
Additional Resources
.
Refer to the Kinetix Motion Control Selection Guide, publication
GMC-SG001
, for
information on feedback, power, and brake cables or connector kits.
Shaft Seals
A shaft seal provides a barrier to moisture and particle entering the motor bearings.
Motors are shipped with a polytetrafluoroethylene (PTFE) shaft seal installed.
Catalog numbers and dimensions for replacement shaft seals are listed in the table.
Refer to the Shaft-seal Kit Installation Instructions, publication
2090-IN012
, for
instructions on how to install a shaft seal.
Motor Cat.
No.
Inside Diameter
mm (in.)
Outside Diameter
mm (in.)
Width
mm (in.)
MPF-A310, -A320,
-A330, -B310,
-B320, and -B330
MPF-SST-A3B3
23 (0.90)
47 (1.85)
6 (0.24)
MPF-A430, and
-B430
MPF-SST-A4B4
26 (1.02)
52 (2.05)
6 (0.24)
MPF-A4530,
-A4540, -B4530
and -B4540
MPF-SST-A45B45
31 (1.22)
62 (2.44)
7 (0.27)
MPF-A540, and
-B540
MPF-SST-F165
36 (1.42)
72 (2.84)
7 (0.27)
IMPORTANT
Shaft seals must be lubricated using a food grade polyurea base grease, such as Chevron
FM (NLGI 2). Lubricated shaft seals are typically replaced at 12 month intervals. Lubricant
is supplied with shaft seal kits.
