Rockwell Automation COLLINS MP-20, Руководство оператора

Страница: 19 / 26

19
Operation
Perform the procedures described in Preparation for Use before proceeding with
either of the following preliminary setup procedures.
CAUTION
Do not operate the radio set without a suitable antenna. Make sure the antenna is
properly connected before tuning the radio set.
Preliminary setup for mobile use
A . Using shoulder straps and waist strap, secure assembled radio set to back of
carrier. Both the left shoulder strap and the waist strap have quick release
assemblies, which should be secure as shown in figure 13. Adjust shoulder straps,
waist strap, and lower backstrap for maximum comfort.
Figure 13. Shoulder Strap and Waist Strap Quick Releases
B . Position whip antenna in a vertical position by pulling up antenna mount and
then releasing in correct detent.
C . If the 540K-1 Control Extender is being used, loop over the shoulder and clip it
onto the belt of the operator.
D . If the 540L-1 Battery Cable is being used, place the battery bag over the shoulder
and strap it around the thigh of the operator, under the outer garments. Plug the
battery end of the cable into the battery connector and tighten the thumbscrew.
E . If the telegraph key is being used, strap the key to the thigh. Plug cable into
connector on 377L-2 Receiver-Transmitter Control. Adjust key gap and tension as
desired