Rockwell Automation Allen-Bradley Kinetix 3 2071-A10, Руководство пользователя

Страница: 70 / 134

70 Rockwell Automation Publication 2071-UM001E-EN-P - November 2013
Chapter 4 Connect the Kinetix 3 Drive
Apply the Motor Cable Shield
Clamp This procedure assumes you have completed wiring your motor power (MP)
connector and are ready to apply the cable shield clamp.
Follow these steps to apply the motor cable shield clamp.
1.
Locate a suitable position for installing the cable shield clamp within
50…75 mm (2…3 in.) of the drive.
2.
Lay out and drill holes for the cable clamp.
3.
Locate the position on the motor power cable that comes under the clamp
and remove about an 25.4 mm (1.0 in.) of the cable jacket to expose the
shield braid.
4.
Position the exposed portion of the cable braid directly in line with the
clamp.
5.
Clamp the exposed shield to the panel with the clamp and two #6-32 x 1
screws provided.
6.
Repeat steps 1 … 5 for each Kinetix 3 drive you are installing.
50…75 mm
(2…3 in.)
50…75 mm
(2…3 in.)
34.0
(1.34)
25
(1.0)
12.7
(0.50)
If panel is painted, remove paint to
provide metal-to-metal contact.
Motor Power Ground
Shield Clamp
Dimension are in mm (in.).
ATTENTION: Plan the installation of your system so that you can perform all
cutting, drilling, tapping, and welding with the system removed from the
enclosure. Because the system is of the open type construction, be careful to
keep any metal debris from falling into it. Metal debris or other foreign matter
can become lodged in the circuitry that can result in damage to components.