Rockville Power Gig RPG122K, Руководство пользователя

Страница: 14 / 16

Troubleshooting
PROBLEM
No sound/
distorted sound
No power
Poor Mic sound
Mic feedback
Buzzing sound
1. Make sure the unit is plugged in and the power switch is in the
ON position.
2. Check that the power cable is plugged in tightly to the unit.
3. Check and replace the fuse if necessary. See fuse replacement
diagram on the facing page.
4. If people or equipment tend to step and roll over or stretch
your power cable it can get damaged. Always try a second cable
to test for shorts in original cable. Dispose of original damaged
power cables immediately.
1. Make sure you are using the Mic In port.
2. If using wireless mics connect them into the Line input of your mixer.
Point the mics away from the speaker. Make sure the mics are in
back of the speaker, not in front of it.
Make sure you are using a proper cable. For ¼˝ cables, there are
3 types: instrument, TS (unbalanced), and TRS (balanced). Check
the requirements of the connected gear and the input of the
speaker and make sure you are using the appropirate cable.
1. Check that all appropriate cables are plugged in correctly.
2. Check the Volume settings.
3. Be sure Volume and Gain of appropriate channels are set
above 0 level and matched correctly.
4. Be sure your microphone is on.
5. If using a mixing console make sure fader and balance are set
to center positions and levels are increased.
6. Check the MP3/Line button to ensure the proper source is
selected.
7. If volume and Treble/Bass settings are maxed out, turn one of
them down as you may be overdriving the unit.
SOLUTION
Bluetooth pairing
fails 1. Check to see that both devices are turned on and that your
Bluetooth device is discoverable.
2. Turn both devices off and then on again.
3. Make sure you've selected the proper source.
4. Make sure that the Bluetooth device is within 5 feet of the unit.
5. Move both devices away from other Bluetooth devices, micro-
waves, wireless routers, and other electronics.
6. Make sure that the unit is not paired to a previously paired
device.
No SD or USB
playback 1. Make sure you've selected the proper source.
2. Make sure that the audio files are in the specified format.