5
Assembly
The Wireless Speaker Kit, which includes one
speaker unit with connector wires and one
control unit, can be mounted in solid material
or in a hollow or box-type structure.
If the two components are to be installed back
to back, the distance from the front of the
material or box to the back must be at least 2"
but no more than 12" to allow wire connections
to be made.
1. Use a coping or scroll saw or a drill with
a Forstner bit (55985, sold separately) or
hole saw to cut a 1
7
⁄
8
" diameter hole for
mounting the speaker and control units.
Fig. 1. Solid material will require a through
hole; a hollow box will require matching
holes in front and back.
2. Press fit or, if desired, epoxy the
speaker unit into the front of the mounting
structure. Make sure you will have access
to the color-coded wires/connectors. Be
sure to wipe away any excess epoxy.
3. Connect the wires from the speaker unit to
the control unit, pressing the red connector
at the end of one set of wires into the red
port on the back of the control unit and the
white connecter on the other set of wires
into the white port.
Fig. 2.
4. Push the wires inside the opening and
press fit or epoxy the control unit into
the rear mounting hole.
Recommended
interior dimensions of speaker
enclosure: 3
1
⁄
4
" x 3
1
⁄
4
" x 2
3
⁄
8
".
When working
with epoxy, make sure the area is
well-ventilated, wear nitrile gloves and
use an applicator. Avoid contact with
skin or clothing.
Fig. 2
Fig. 1
