6
Need help? Call 800-620-2790
RF-TVMLPT02V2 TV Wall Mount
STEP 2 -
Option 1: Installing on a wood stud wall
Note
: Drywall covering the wall must not exceed 5/8" (16 mm).
1
Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2
Align the wall platetemplate (
D
) at the height you determined in the previous step and make sure that it is
level. Tape the template (
D
) to the wall, then use a pencil to mark the lag bolt hole locations (2) on the stud
centers. Remove the wall plate template (
D
).
3
Drill pilot holes to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill bit.
4
Align the wall plate (
A
) with the pilot holes, insert the lag bolts (
R
) through the lag washers (
Q
) and the holes
in the wall plate, then tighten the lag bolts only until they are firm against the wall plate.
CAUTION
: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (
R
).
You’ll need
3 in.
(75 mm)
Note
: Minimum wood stud size: common
51 x 102 mm (2 x 4 in.) nominal 38 x 89
mm (1.5 x 3.5 in.)
Center pencil mark made in
Step 1.
Q
(2)
Edge-to edge
stud finder
R
(2)
Pencil
Drill
7/32" wood
drill bit
1/2" socket
wrench
Level
Tape
(
D
) Template
Top
Dessus
Parte superior
Top
Dessus
Parte superior
RF-TVMLPT02V2
Template • Gabarit • Plantilla
Note
: For wood frame installations, use a stud
finder to locate wood studs first.
Remarque
: Pour une construction à ossature
de bois, localiser d'abord les montants en bois,
à l'aide d'un détecteur de montants.
Nota
: para la instalación en construcciones de
armazón de madera, primero debe localizar las
vigas de madera con un localizador de vigas.
Need help deciding how high to mount your TV? Scan this QR code.
Besoin d'aide pour déterminer la hauteur de montage du téléviseur?
Numériser ce code QR.
¿Necesita ayuda para determinar la altura de montaje de su
televisor? Escanee este código QR.
V2 13-0195
Tools Needed
Outils nécessaires
Herramientas requeridas
Wall plate (
A
)
RF-TVMLPT02V2_13-0194_MAN_V2_EN - GIFs.fm Page 6 Thursday, March 14, 2013 12:01 PM
