Rock The Bike Fender Blender Pro High Performance, Руководство пользователя

Страница: 4 / 9

1. Place the frame on its side on a soft surface such as carpet
or cardboard.
2. Using the smaller bolts and washers, connect the crossbeam
to the frame, make sure the feet are facing down and the
wheel sockets facing forward.
3. Tighten the bolts securely using the 6mm hex key.
1. Turn frame back over on to crossbeam.
2. Align the holes in the rear legs with the holes through the frame.
3. Insert the larger set of bolts, tighten each four turns to make
sure the threads are in place.
4. Firmly tighten the bolts with the 8mm hex key.
6 7
CROSSBEAM
REAR LEGS
Damage can occur if not tight.
If the left pedal needs to be removed, rotate the threaded
portion counter-clockwise.
Make sure the spring
cones of the skewer are
pointing inward.
1. Identify the right side pedal by it’s sticker or stamp, then install
it into the right crank arm using the 15mm wrench.
2. Once the pedal is fully threaded into the crank arm, give it a
good, hard turn to secure.
if you purchased a generator wheel,
refer to its assembly instructions
PEDALS
1. Insert the wheel skewer
through the wheel axel.
2. Once the skewer is inside
the axle, insert the spring
cone, then tighten the nut
three times.
WHEEL
assembly
ASSEMBLY