RocHobby ROC11242RTRCE, Инструкция по эксплуатации

Страница: 11 / 44

11
EN
This function is used to protect the safety of the model and the operator when the receiver cannot
normally receive the signal from the transmitter and is out of control. The receiver defaults that the
throttle channel is fixed to be out of control and enters the brake state. After other channels are out
of control, the receiver has no signal output. If you set it on the transmitter, it will output according to
the set value.
Attention:
• Make sure the product is installed and calibrated correctly, failure to do so may result in serious
injury.
• Please carefully check each power device and car frame instructions to ensure the power matching
is reasonable before use. Avoid damaging power system due to incorrect matching.
• Do not let the external temperature of the system exceed 90°C /194°F , because high temperature
will damage the power system.
• Make sure the receiver's battery is disconnected before turning off the transmitter, failure to do so
may lead to unintended operation or loss of control.
• After use, remember to disconnect the battery and the ESC. If the battery isn't disconnected, the
ESC will consume electric energy all the time even if it is off. It will discharge completely if connect
the battery for a long time, thus resulting in the failure of the battery or the ESC. We are not
responsible for any damage caused by this!
• Make sure the receiver is mounted away from motors or any device that emits excessive electrical
noise.
• Keep the antenna of the receiver at least 1cm away from conductive materials such as carbon or
metal.
• Do not power on the receiver during the setup process to prevent loss of control.
Failsafe
ESC Parameter Setting
Dial Switch sign
Running Mode
FWD/REV/BRK
FWD/REV
Lipo
NiMH
0%
50%
75%
100%
Battery Type Drag Brake
Setting Method:
There are three parameters can be set for the ESC, which are "Running mode", "Battery type", "Drag
brake", There are slide switches numbered 1 2 3 4 on the radio panel . The above parameters can be
set by dialing down and up.
The specific operation is as follows:
The Dial Switch on the transmitter is used to set ESC parameters, that is, the Dial Switch is located
at different positions and the corresponding parameter values are different.