RocHobby FMMROC009RTR, Инструкция по эксплуатации

Страница: 8 / 76

F.Reset
REV
ST TRIM
TH TRIM
LED
Train
Climbing
In the use of the disorder
settings, not back to the normal
state, you can use Factory.Reset
function
A/B mode function toggle switch
After replacing the steering
gear, the steering gear is
reversed
After replacing the motor, there
is a reverse
Adjust 30 / 50 / 100% steering
radian
When the steering center is not
centered
When the throttle is not
centered
Light setting
Adjust the training mode for
beginners
Adjust climbing mode
Emitter: forget reminder
Transmitter: frequency alert
If the transmitter does not receive any command, it will give an alarm after 10 minutes
and enter sleep mode after 2 minutes
When the transmitter does not match the receiver, the indicator light of the transmitter
keeps flashing
Transmitter: no frequency matching
+ low power reminder 4.5V
Transmitter: low power reminder 4.5V
The indicator light of the transmitter flashes slowly and makes a sound
The indicator light of the transmitter flashes slowly
Car: frequency alert
Car: low power alarm 6.3-6.4v The headlights keep flashing
All lights keep flashing, steering and throttle are not controlled
Car: reminders to prevent
forgetting
If the vehicle does not receive any signal, it will flash back and forth after 10 minutes
and enter sleep mode after 2 minutes
Make sure that the mode function toggle switch is in mode A, hold the steering wheel
left or right, and click the F. Reset button at the same time. After two clicks, it means
that the factory settings have been completed.
Make sure that the mode function toggle switch is in mode A, twist the left or right
steering wheel, and click Rev button at the same time. After ringing, it means that the
reverse setting of steering gear has been completed.
Make sure that the mode function toggle switch is in mode B, and click the ST Angle
key. After a click, it means that the 30% steering radian has been set. Click the ST
Angle button again, and you will hear two beeps, indicating that the setting of 50%
steering radian has been completed. Click the ST Angle button again, and you will
hear three beeps, indicating that the 100% steering radian has been set. Then click to
cycle to a click to indicate that the 30% steering radian has been set.
Make sure that the mode function toggle switch is in mode A, pull or push the throttle,
and click Rev button at the same time. After ringing, it means that the motor reverse
setting has been completed.
Make sure that the mode function toggle switch is in mode A, press ST TRIM+ or -
button to fine tune the steering center. Every click of the button will ring. When the
maximum and minimum values are reached, a long sound will appear. When the
median value is reached, it will ring twice.
Make sure that the mode function toggle switch is in mode A, press TH TRIM + / -
button to fine tune the throttle center. Every click of the button will ring. When reach-
ing the maximum and minimum value, the button will ring, when reaching the
median value, the button ring twice.
Make sure that the mode function toggle switch is in mode B, click the LED button,
and the headlamp will be on after a click. Then click the LED button, and the
headlight will be highlighted after two clicks. Continue to click the LED button, and
the air defense light will be on after three rings.
Make sure that the mode function toggle switch is in mode B, click the Train button,
and after a click, enter the beginner training mode. At present, the throttle speed is
limited to 50%. Press it again, and it will return to normal after hearing two rings.
Make sure that the mode function toggle switch is in mode B, click the Climbing
button, and enter the climbing mode after a click. When the accelerator is released,
the braking function starts. It's not easy to reverse when going up a steep slope. Press
it again, and it will return to the normal state after hearing two rings.
08
EN