RocHobby DPROC001RS, Инструкция по эксплуатации

Страница: 8 / 76

AU
X 3 2
1
Channel connection
Channel 1: Controlled by the wheel, connect to a servo for steering.
•
Channel 2: Controlled by the trigger, connect to the ESC or a servo for throttle/brake.
•
Channel 3: Controlled by the adjustment knob (0-100%) for optional use. This port can also be used to connect a transpon-
der device used in racing. •
AUX (Channel 4): Controlled by button (ON/OFF) for optional use. This port is most commonly used for LED light kits. Use
this port to connect an external battery for use with gas powered vehicles. •
Pairing the transmitter & receiver
Note: Radio systems installed in RTRs have already been paired. Only when installing a new transmitter
or receiver is the above process necessary.
2. Turn on the transmitter.
3. When the LED on the receiver becomes solid,the binding process is completed.
1. Turn on the receiver power. Press the SW switch.The receiver’s LED should start flashing.
Receiver installation & connection
Receiver
CH1
CH2
CH3
CH4
Throttle Servo
Channel 3 Servo
Channel 4 Servo
Connect to
receiver battery
Y-line
07
Ensure there are no kinks in the antenna or antenna tube.
•
Never fold the end of the antenna over the tube, this will reduce the operating range of the system and damage the antenna.
•
Ensure the receiver is mounted securely or padded against hard impacts.
•
To achieve full operating range with your radio system it is critical that the receiver antenna be undamaged and
installed properly. It should be installed with as much of the antenna as possible in a vertical position. The end of
the antenna should be contained inside an antenna tube. When installing:
Installation
EN