Roche OMNI C, Инструкция по эксплуатации

Страница: 26 / 152

1 Introduction
1-18
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
2. Installing the AutoQC module (Automatic Quality Control Module)
IMPORTANT: Attempt to install and operate an AutoQC module only if the instrument is
prepared for use with the AutoQC module. The valves V12 and V13 must be
present in the bottle compartment (see Fig. 11)!
Fig. 11
IMPORTANT: Check to be sure that the power cord is connected to the power supply. After
engaging the AutoQC module, it will no longer be possible to connect the
cord to the power supply!
•
Open the AutoQC cover and remove the transport safety band and both safety screws
(see Fig. 12/1).
TIP: The safety screws are intended to fix the longitudinal and transversal slides and
should only be re-inserted whenever the AutoQC module will be transported.
• Remove upward thered, the red plastic relief clamp from the AQC valve V17, which is
located toward the back of the AQC unit on the inside (see Fig. 12/2).
Fig. 12
• On the right side of the Roche OMNI C, remove the gray plastic cover from the AutoQC
docking port. Close the AutoQC cover and push the AutoQC module into the tracks on
the Roche OMNI C until it locks into place.
V13
V12
not prepared
prepared
(1)
(2)