Robustel R2110 Hardware Manual
RT044_HM_R2110
8/11
3. Reset Button. (TBD)
Function
Operation
Reboot
Press and hold the RST button for 2~ 5 seconds under the operating status.
Restore to default
configuration
Press and hold the RST button for 5~10 seconds, the RUN LED starts blinking quickly, the router will restore to default
configuration.
Restore to factory
default settings
Once the operation of restoring default configuration is performed twice within one minute, the router will restore to factory
default settings.
Note: The more details please refer to
RT123_SM_RobustOS Software Manual, 2.3 Factory Reset.
4. Ethernet Ports.
There are four Ethernet ports on R2110-4L, including ETH0 (POE), ETH1, ETH2, ETH3. Each has
two LED indicators. The yellow one is a link indicator but the green one doesn’t mean anything. For details
about status, see the table below.
Indicator
Status
Description
Link indicator
(Yellow)
On, solid
Connection is established
On, blinking
Data is being transferred
Off
Connection is not established
5. Digital IO & Serial Port.
2x5PIN 3.5mm pitch terminal block, 1 set of DO, 1 set of DI, 1 x RS232 and 1 x RS485.
DI signal access, can be used for NPN/PNP type sensor signal or switch signal acquisition. DO signal output,
can be used for NPN/PNP sensor control, please connect signals by referring to typical applications.
PIN
DI/DO
RS232
RS485
Direction
1
IGND
--
--
--
Internal diagram of DI&DO
2
OGND
--
--
--
3
--
TXD
--
Router
Device
4
--
RXD
--
Router
Device
5
--
GND
--
--
6
IN
--
--
--
7
OUT
--
--
--
8
--
--
A
--
9
--
--
B
--
10
--
--
GND
--
Application:
DI connected with NPN sensor
DI connected with PNP sensor
DO Driven NPN Triode
DO Driven PNP Triode
Note:
The external power supply DC voltage range is 3V~30V.
6. USB Interface.
Function
Operation
Firmware upgrade
USB interface is used for batch firmware upgrading, but cannot be used for sending or receiving data from slave devices which
connected to it. You can insert a USB storage device into the router’s USB interface, such as a U disk or a hard disk. If there have a
supported configuration file or a router firmware in this USB storage device, the router will automatically update the
configuration file or the firmware. For more details, see
RT123_SM_RobustOS Software Manual
.
