RoboVent VentBoss 300 Series, Руководство пользователя

Страница: 18 / 32

18 VENTBOSS
•
SERIES 300 SPACE SAVER COLLECTORS OWNER’S MANUAL
SECTION 700
MAINTENANCE
(continued)
FIGURE 14
FIGURE 15
FIGURE 16
the system is greatly increased. Typically, these baffles
should be removed and cleaned with a hot detergent
solution every month. Filters that are bent or deformed
beyond repair should be replaced. See Equipment
Specifications Sheets for ordering proper replacements.
CAUTION! DO NOT replace these baffle filters with
anything other than what was originally installed in your
unit. Failure to do so will greatly increase the risk of fire.
Placement of the first layer baffle filter is extremely
important as the baffles should run vertical with cup side
facing the direction the air is flowing from. Failure to
place the baffle as shown will increase the risk of fire.
Particulate Removal (Cleaning)
The dust containment area is located immediately
below the cartridge filter and can be accessed through
the filter door. Cleaning frequency of the dust bin will
vary depending on the welding situation and use.
Periodically check the bin for particulate. When 2-3
inches of dust forms at the bottom of the bin remove
with a vacuum or brush and pan. (Figure 14)
Blower Maintenance
The motor and blower in your VentBoss Series 300 unit
will require very little attention, although it is important
to make sure it is kept clean. If your motor is fitted
with grease nipples, they must be lubricated every six
months. (Figure 15) Installation of a new blower wheel
requires a certified VentBoss Technician to balance the
wheel and motor. Contact 1.855.558.VENT.
Solenoid Valve Maintenance
The Pulse Solenoid is located in the rear of the Motor
Plenum. (Figure 16) Under normal conditions, the pulse
valve will last for the life of the collector. Clean, dry
compressed air, at 85 PSI, will help towards a long,
maintenance free life of the solenoid. (See Specifications
Sheet for replacement information)