Operation &
Maintenance Manual
Pump
RW-R
782-007-GB
HSC
02-W51
Edition 1
5/28
3.
SAFETY AND ENVIRONMENT
3.1
Symbols
*
In this manual
General warning
Danger !
Electrical hazard !
Attention !
*
On the pump
Danger of physical injury
Rotating parts !
Electrical hazard !
EC-conformity symbol
3.2 General safety instructions
*
Only trained and authorized personalmay install and
maintain the pump after carefully reading this
manual.
*
Only use the pump for its intended purpose and
under the regulated circumstances.
*
Don’t go near rotating parts.
*
Clean the pump before maintenance and inspection.
*
Observe the local regulations when working with
agressive, corrosive, toxic, flameable and explosive
chemicals.
*
Never remove safety signs, keep them clean.
*
Always connect to a grounded circuit.
*
Before maintenance and inspection always
disconnect the pump from the mains.
*
Use a proper hoist for lifting and handling the pump.
*
Do not leave a large loop of cable in the sump,
as the pump may eventually damage it.
*
Never drop the loose cable end in water. The water
may enter the cable and finally enter the
motorhousing, eventually causing motor failure.
3.3 Environment
Parts which are replaced during repair, maintenance or
renewal, could contain materials which could be harmful
to the environment.
Please take care in the disposal of these parts.
Do this in accordance with the local environmental
regulations.
www.robotpompen-onderdelen.nl
T +31(0)294-457712
