Robot Coupe MP 350 Combi Ultra, Руководство пользователя

Страница: 13 / 21

12
27/11/2020
MAINTENANCE
• BLADES
The performance of the cut essentially depends
on the state of your blades and their wear. The
blades are subject to wear and as such need to be
replaced from time to time to ensure the consistent
quality of the end product.
You are also advised to change, at the same time,
the washer and the watertight seals.
• WHISKS
The success of your preparation will depend
essentially on the state of the metal wires and
their amount of wear and tear. They should
therefore be replaced from time to time in
order to ensure optimum quality of the finished
product.
• POWER CORD:
For your safety, make sure the power cord is
always in good condition. The cord is subjected
to considerable wear and tear, and must be
replaced if it is damaged in any way (cuts, burns,
etc.).
I M P O R T A N T
Check that your detergent is suitable for
cleaning plastic parts. Some washing agents
are too alkaline (e.g. high levels of caustic
soda or ammonia) and totally incompatible
with certain types of plastic, causing them to
deteriorate rapidly.
• BLADES
The blades can be removed from the bell for tho-
rough cleaning.
Always dry the blades thoroughly after cleaning to
avoid spotting.
The blades are sharp and must be handled with
care.
• WHISK HOLDER
Never immerse the whisk holder in water.
Clean with a throwaway wiper.
Never clean the whisk holder in a dishwasher.
• WHISKS
The whisks can be cleaned either by hand or in a
dishwasher.
To ensure effective cleaning, we advice you to
remove the whisk ejector.
• MIXING TOOL HOUSING
Never immerse the mixing tool
housing in water or put it in the
dishwasher. Instead, clean it with a
slightly damp cloth.
• MIXING TOOL
The mixing tool can be washed either
by hand or in the dishwasher. You
can also clean it with a slightly damp
cloth.
6) Carefully dismount the different parts of the
bell using the tool provided taking care not
to damage the blade shaft surfaces and car-
tridge gaskets. Clean each part using a mild
detergent. The blades are sharp and must be
handled with care.
7) Immerse the foot, detached from the bell, in a
mild detergent solution for one minute. Rinse and
let dry before re-attaching the bell.
8) After cleaning, dry all the parts carefully to
prevent oxidation.
W A R N I N G
The inside of the bell must not contain any
liquid or food matter besides condensation.
If any liquid or food matter should get inside
the bell, you must:
- Change the cartridge,
- Clean and disinfect the bell and the end of
the foot to avoid all risk of contamination.
After each use:
- It is important to detach the bell to eliminate
any condensation and ensure no food
matter has seeped inside. To eliminate
condensation, simply leave the bell
detached until it dries.
- When cleaning the bell and the end of
the foot, we recommend using a mild
detergent.