20
> 0.5 m (1.6 ft)
> 0.5 m (1.6 ft)
> 1 m (3.3 ft)
> 1.5 m (4.9 ft)
Powering On & Charging
Press and hold the button to power on the robot. Wait until the power
light is steady, and then place the robot on the dock to charge. The robot
is equipped with a built-in high-performance lithium-ion rechargeable
battery pack. To maintain battery performance, keep the robot charged
during normal use.
Placement of the Dock
Place the dock on a hard and flat floor (wood/tile/concrete etc.), flat
against a wall. Keep at least 0.5 m (1.6 ft) of clearance on either side, 1.5 m
(4.9 ft) in front, and 1 m (3 ft) above. Check the location has good WiFi for
a better experience with the mobile app, and then turn it on.
Note:
The robot may not be turned on when the battery is low. In this case, connect the robot to the dock.
The color of the
power indicator
indicates the
battery level.
•
White: ≥ 20%
•
Red: < 20%
Notes:
Installation
•
If the power cable hangs vertically to the ground, it may be caught by the robot, causing the
dock to be moved or disconnected.
•
The dock indicator is on when the dock is powered on, and off when the robot is charging.
•
The dock indicator turns red if an error occurs.
•
Place the dock on a flat floor away from fire, heat, and water. Avoid narrow spaces or locations
where the robot may be suspended in the air.
•
Placing the dock on a soft surface (carpet/mat) may cause the dock to tilt over and cause
problems docking and departing.
•
Keep the dock away from direct sunlight or anything that may block the dock location beacon;
otherwise, the robot may fail to return to the dock.
•
Do not use the dock without clean water tank, dirty water tank, high-speed maintenance brush,
or water filter.
•
Maintain the dock according to the maintenance instructions. Do not clean the dock with a wet
cloth or tissue.
•
All docks are subject to water-based tests before leaving the factory. It is normal that a small
amount of water remains in the waterway of the dock.
